Fabricating for a function pt.2

So, for this model it’s fairly simple it’s just a bookmark with an extra limp on the side to hold the charging cord. The reason that the part that has to hold the charging cord sticks out from the main wall is the charging cable that is going to go in it has the large bulge on it that will have to fit in-between the main wall and the part that holds the charger. The bottom also has longer stilts on the side that the controller will sit because I expect that the controller will weigh a lot more then the disks and boxes on the other side. I might need to add some stilts the hold the controller upright but I’m not sure yet. I’m afraid that the controller won’t stay upright on its own while connected to the charger. Also, I want the controller to be able to lean on the bookmark without being connected to the charger. The entire structure stands 5 in tall which is just a little shorter than the cases that it will be holding up. The boarder and X in the middle are all .5 in wide and 5 mm thick. The base in one side is only one inch long and on the other side it’s 3 in long and both are 5 mm thick. The height of the curve that holds the cord is 20 mm.